Room EQ Wizard - Sub Measurements

The first measurement of the left subwoofer:

2008-08-08
These are from a second measurement session.

Left Sub - Position 1:


Right Sub - Position 5:

Combined - Left Sub Position 1 and Right Sub Position 5 (no EQ):

Combined - Left Sub Position 1 and Right Sub Position 5 (with EQ):

Combined - Left Sub Position 1 and Right Sub Position 5 (updated EQ):
Left Sub EQ

16Hz, L -3.0, Q 4.0
21Hz, L -6.0, Q 1.3
22Hz, L -7.0, Q 0.6
40Hz, L -3.0, Q 5.0
55Hz, L +3.0, Q 1.3
84Hz, L +3.0, Q13.8

Right Sub EQ

20Hz, L -3.0, Q 5.0
29Hz, L -9.0, Q 0.5
30Hz, L -7.0, Q 0.6
80Hz, L +4.0, Q 10.0
102Hz, L +3.0, Q 12.6

Behringer DCX2496

The following describes my setup of the DCX2496.

EQ Settings Set 1: These are variable settings for Baffle Step Correction and the High Frequency Compensation(Toole Curve).

EQ Settings Set 2: Non-variable settings

Input/Outputs:

• Input A - Front Left
• Input B - Front Center
• Input C - Front Right

• Output 1 - Front Left Sub (will be used in the near future)
  
• Output 2 - Front Left Main
• Output 3 - Front Center Sub (will not be used)
  
• Output 4 - Front Center Main
  
• Output 5 - Front Right Sub (will be used in the near future)
• Output 6 - Front Right Main

Steps taken:

• Set "Out Configuration" to "LH LH LH"
• Set "In Stereo Link" to "A+B+C"

• Confirmed routing for Input A -> Output 1 and 2, Input B -> Output 3 and 4, Input C -> Output 5 and 6

• Clicked on Input A : EQ and added Set 1 settings
• Confirmed these were copied to Inputs B and C
  

• Clicked on Output 2 : EQ and added Set 2 settings
• Clicked on Output 4 : EQ and added Set 2 settings
• Clicked on Output 6 : EQ and added Set 2 settings

• Changed X-Over to 86 Hz for Outputs 1,3,5 (outputs not used at this point)
• Changed X-Over to Off for Outputs 2,4,6 (until subs are hooked up)

Display Tab:

Sum/Setup Tab:

Routing Tab:

X-Over Tab (Ch1 and Ch2 as example):

EQ Tab (Ch1 and Ch2 as example):